Ford Ranger Maintaince And Repair Manual page 234

Hide thumbs Also See for Ranger:

Table of Contents

Install the brush holder on the regulator with 2 retaining screws. Tighten the screws to 25−35 inch lbs.

(2.8−4.0 Nm).

Exploded view of the voltage regulator and brush holder assembly

Install the cap on the head of the Aterminal screw.

Depress the brushes into the holder and hold the brushes in position by inserting a standard size paper

clip, or equivalent tool, through both the location hole in the regulator and through the holes in the

Install the regulator/brush holder assembly and remove the paper clip. Install the attaching screws and

tighten to 20−30 inch lbs. (2.3−3.4 Nm).

Connect the negative battery cable.

1995−99 models with integral type regulator

The internal voltage regulator used on alternators used with these vehicles is not removable or, in any other

way, serviceable. If the voltage regulator is found to be defective, a new alternator must be installed.

REMOVAL & INSTALLATION

HOW TO USE THIS BOOK

Click to enlarge

Troubleshooting

Mountaineer Explorer