Ford Ranger Maintaince And Repair Manual page 366

3.0L Engine
1. Disconnect the negative battery cable.
2. Remove the oil level dipstick.
3. Remove the fan shroud. Leave the fan shroud over the fan assembly.
4. Remove the motor mount nuts from the frame.
On models equipped with distributor ignition, failure to remove the distributor will damage or break it when
the engine is lifted.
5. If equipped, mark and remove the distributor assembly from the engine.
6. Raise and support the vehicle safely. Remove the oil level sensor wire.
7. Drain the engine oil from the crankcase into a suitable container and dispose of it properly.
The EPA warns that prolonged contact with used engine oil may cause a number of skin disorders, including
cancer! You should make every effort to minimize your exposure to used engine oil. Protective gloves should
be worn when changing the oil. Wash your hands and any other exposed skin areas as soon as possible after
exposure to used engine oil. Soap and water, or waterless hand cleaner should be used.
8. Remove the starter motor from the engine.
9. Remove the transmission inspection cover.
10. Remove the right hand axle I−Beam. The brake caliper must be removed and secured out of the way.
Refer to the necessary service procedures.
11. Remove the oil pan attaching bolts, using a suitable lifting device, raise the engine about 2 inches.
Remove the oil pan from the engine block.
Oil pan fits tightly between the transmission spacer plate and oil pump pickup tube. Use care when
removing the oil pan from the engine.
12. Clean all gasket surfaces on the engine and oil pan. Remove all traces of old gasket and/or sealer.
To install:
13. Apply a 4mm bead of RTV sealer to the junctions of the rear main bearing cap and block, and the
front cover and block. The sealer sets in 15 minutes, so work quickly!
14. Apply adhesive to the gasket mating surfaces and install oil pan gasket.
15. Install the oil pan on the engine block.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
WARNING
CAUTION
359