Ford Ranger Maintaince And Repair Manual page 871

Hide thumbs Also See for Ranger:

Table of Contents

Install the retainer using the proper installer tool. Be sure that the retainer is properly seated.

Use a suitably sized driver to install the inner bearing seal to the hub

Install the hub and rotor assembly onto the spindle. Keep the hub centered on the spindle to prevent

damage to the spindle and the retainer.

Install the outer bearing cone and roller assembly and flatwasher on the spindle. Install the adjusting

nut. Adjust the wheel bearings.

Install the retainer, a new cotter pin and the grease cap. Install the caliper.

Lower the vehicle and tighten the lug nuts to 100 ft. lbs. Before driving the vehicle pump the brake

pedal several times to restore normal brake pedal travel.

Retighten the wheel lug nuts to specification after about 500 miles of driving. Failure to do this could result in

the wheel coming off while the vehicle is in motion possibly causing loss of vehicle control or collision.

REMOVAL & INSTALLATION

HOW TO USE THIS BOOK

Apply a thin coat of fresh grease to the new seal lip

Troubleshooting

Mountaineer Explorer