Ford Ranger Maintaince And Repair Manual page 1029

The Tension Limiter will reset the parking brake tension any time the system is disconnected provided
the distance between the bracket and the cinch strap hook is reduced during adjustment. When the
cinch strap contacts the bracket, the system tension will increase significantly and over tensioning may
result. If all available adjustment travel has been used, the tension limiter must be replaced.
1993−99 Models
Starting in 1993, all models use a self−adjusting parking brake cable assembly. However, in order to remove
any of the cables or components, the following procedures must be followed.
CABLE TENSION RELEASE
With the parking brake released, insert the pin into the brake control assembly as shown to lock
Method 1:
1. Place the parking brake cable control in the released position.
2. Have an assistant pull on the intermediate brake cable while you insert a
pin (or drill bit) into the hole provided in the parking brake control assembly.
3. To release the cable tension, pull out the lock pin from the control assembly.
Method 2:
For relieving tension from the rear cables only.
4. Pull backwards on the rear cable and conduit about 1.0−2.0 in. (25−50mm) and place a clamp on the
parking brake cable and conduit behind the rear crossmember.
5. To release the cable tension, remove the clamp holding the rear cable to the crossmember.
1050
HOW TO USE THIS BOOK
the cable tension spring
Ensure that you do not damage the nylon coating on the cable.
WARNING
5
/ in. (4mm) diameter steel
32
ADJUSTMENT