Ford Ranger Maintaince And Repair Manual page 1050

Exploded view of the Explorer/Mountaineer rear door hinge assembly
1. If replacing the door with a stripped unit, remove all usable components from the old door.
2. If removing the rear door (Explorer), remove the scuff plate and center panel trim panel. Remove the
upper and lower hinge access cover plate if equipped, and matchmark the hinge−to−body and
hinge−to−door location. Support the door either on jackstands or have somebody hold it for you.
3. Remove the lower hinge−to−door bolts.
4. Remove the upper hinge−to−door bolts and lift the door off the hinges.
5. If the hinges are being replaced, remove them from the door pillar.
To install:
6. If they were removed, install the hinges in the same position as before removal. Tighten the bolts
finger tight.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
Click to enlarge
1073