Fuel Supply Manifold And Injectors - Ford Ranger Maintaince And Repair Manual

Remove the old gasket and thoroughly clean the mating surfaces of both pieces
6. Remove and discard the old throttle body−to−intake manifold gasket.
To install:
If scraping is necessary to clean the remaining gasket material off of the mating surfaces, take care to
avoid scratching or gouging the soft aluminum.
7. Clean the gasket mating surfaces of any residual gasket material.
8. Install the throttle body, along with a new gasket, onto the upper intake manifold. Install and tighten
the mounting nuts in a crisscross pattern to specifications.
9. Engage the TP sensor and IAC valve wiring connectors and remove the temporary labels.
10. Reattach the accelerator and speed control cables, if applicable, to the throttle body lever.
11. If removed, install the throttle linkage shield.
12. Install the air inlet tube between the air cleaner housing and the throttle body. Tighten the tube clamps
until snug.

Fuel Supply Manifold and Injectors

Fuel Supply Manifold and Injectors
HOW TO USE THIS BOOK
... then remove the throttle body assembly
625