Ford Ranger Maintaince And Repair Manual page 334

16. Install the lower hose and connect the radiator hose.
17. Install the pulley and hand−tighten the 4 bolts.
18. Install the alternator adjusting arm and brace.
19. Install the belts and tension them. See Section 1.
20. Tighten the 4 pulley bolts to 19 ft. lbs.
21. Install the fan.
22. Fill and bleed the cooling system.
23. Connect the battery ground cable. Run the engine and check for leaks.
4.0L Engine (VIN X)
1. Disconnect the negative battery cable.
2. Drain the cooling system.
When draining the coolant, keep in mind that cats and dogs are attracted by ethylene glycol antifreeze, and are
quite likely to drink any that is left in an uncovered container or in puddles on the ground. This will prove
fatal in sufficient quantity. Always drain the coolant into a sealable container. Coolant should be reused unless
it is contaminated or several years old.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
3.0L engine water pump and front cover fastener chart
Click to enlarge
CAUTION
327