Case−to−extension bolt torque sequence for all models except the AWD transfer case
17.
Install the heat shield onto the transfer case, if equipped, and place a new gasket between the transfer
case and adapter.
18.
Raise the transfer case with a suitable transmission jack or equivalent, raise it high enough so that the
transmission output shaft aligns with the splined transfer case input shaft.
19.
Slide the transfer case forward on to the transmission output shaft and onto the dowel pin. Install
transfer case retaining bolts and torque them to specification.
20.
The remainder of the installation procedure is the reverse of removal. Check the fluid level and, if
necessary, top off with Dexron/Mercon automatic transmission fluid to achieve the proper level.
ADJUSTMENTS
Manual Shift Models
ADJUSTMENTS
HOW TO USE THIS BOOK
799