Back−Up Light Switch - Ford Ranger Maintaince And Repair Manual

Exploded view of the 1995−99 model headlight switch components
To install:
5. Connect the wiring connector to the headlamp switch, position the switch in the instrument panel and
install the mounting nut.
6. On 1995−99 models, install the instrument panel finish panel.
7. On 1991−94 models, perform the following:
1. Install the headlamp switch knob and shaft assembly by pushing the shaft into the switch until
it locks into position.
2. On the Explorer, install the rear window wiper and heated backlite switch assembly.
3. On the Ranger, install the storage bin.
4. Install the finish panel and the ash tray assembly.
8. Connect the battery ground cable, and check the operation of the headlight switch.
Back−up Light Switch
The back−up light switch used on the automatic transmissions is also the neutral safety switch. Refer to
Section 7 for the proper procedures.
Ford used two different manual transmissions, the Mitsubishi and the Mazda made 5−speed OverDrive (OD)
transmissions. The back−up light switch is located on the right side of the transmission on the Mitsubishi, and
on the left side shift cover on the Mazda.
Manual Transmissions
1. Apply the parking brake and place the gear shift lever in any position other than Neutral (N) or
Reverse (R).
2. Raise and safely support the vehicle.
According to the manufacturer, no fluid will leak from the transmission when the switch is removed,
but as a precautionary measure, bring a drain pan under the vehicle with you.
Back−up Light Switch
HOW TO USE THIS BOOK
Click to enlarge
713