Ford Ranger Maintaince And Repair Manual page 741

To access the fuses, remove the fuse panel cover. Note the spare fuses (A) and provided fuse
2. Remove the fuse panel access cover.
3. If equipped, remove the fuse puller tool from the cover.
Using the provided tool or a pair of pliers, grasp the fuse and pull it from the panel
4. Grasp the push−in type fuse with the provided tool, or a pair of needle−nose pliers.
5. Look through the side of the fuse body to determine if the fuse element is blown.
To install:
6. Check the amperage rating of the fuse which was removed and obtain a new fuse of the same rating.
Never replace a blown fuse with a new fuse of a higher rating. Severe electrical damage, as well as possible
electrical fire could result.
7. Align the fuse with its mounting position and push it into place until fully seated in the panel.
8. Turn the ignition switch on and operate the accessory that was protected by that fuse.
REPLACEMENT
HOW TO USE THIS BOOK
puller tool
WARNING
749