Remove the vacuum diaphragm retaining clamp and bolt, then pull the diaphragm out of the
1.
Disconnect the negative battery cable.
2.
Raise and support the vehicle safely.
3.
Disconnect the hose from the vacuum diaphragm.
4.
Remove the vacuum diaphragm retaining clamp bolt and clamp. Do not pry on the clamp.
5.
Pull the vacuum diaphragm from the transmission case and remove the vacuum diaphragm control rod
from the transmission case.
To install:
6.
Install the vacuum diaphragm control rod from the transmission case.
7.
Push the vacuum diaphragm into the case and secure it with the clamp and bolt. Tighten to 80−106
inch lbs. (9−12Nm).
8.
Fit the vacuum hose to the diaphragm.
9.
Lower the vehicle.
10.
Reconnect the negative battery cable.
Extension Housing Seal
REMOVAL & INSTALLATION
780
HOW TO USE THIS BOOK
transmission
Click to enlarge
REMOVAL & INSTALLATION