TESTING
Remove the RABS sensor from the axle housing.
1.
Connect a Digital Volt/Ohm Meter (DVOM) across the two sensor terminals and record the reading.
2.
The reading should be between 0.8 and 1.4 k Ohms.
3.
If not, replace the sensor.
REMOVAL & INSTALLATION
1.
Thoroughly clean the axle housing around the sensor.
2.
Disconnect the electrical harness plug from the sensor.
To remove the rear wheel sensor, first disconnect the electrical harness plug ...
1046
HOW TO USE THIS BOOK
... then remove the sensor−to−axle housing hold−down bolt
TESTING