Ignition Control Module (Icm); Removal & Installation - Ford Ranger Maintaince And Repair Manual

4. Remove the coil pack mounting screws and remove the coil pack.
To install:
5. Install the coil pack and the retaining screws. Tighten the retaining screws to 40−62 inch lbs. (4.5−7
Nm).
Be sure to place some dielectric compound into each spark plug boot prior to installation of the spark
plug wire.
6. Attach the spark plug wires and electrical harness connector to the coil pack.
7. Connect the negative battery cable.

Ignition Control Module (ICM)

REMOVAL & INSTALLATION
Only the EEC−IV ignition systems use an external ICM. EEC−V systems have incorperated the ICM
into the Power Control Module (PCM).
1. Disconnect the negative battery cable.
2. Detach the wiring harness connector(s) from the ICM.
3. Remove the mounting bolts, then remove the ICM.
To install:
4. Position the ICM onto the inner fender apron and install the mounting bolts. Tighten the bolts to
22−31 inch lbs (2.5−3.5 Nm).
5. Attach the wiring harness connector(s) to the ICM.
6. Connect the negative battery cable.
Ignition Control Module (ICM)
HOW TO USE THIS BOOK
... then remove the coil pack from its mounting bracket
207