1.
Disconnect the negative battery cable.
2.
Raise and support the vehicle safely.
3.
Matchmark the driveshaft end yoke and rear axle companion flange to assure proper positioning
during assembly. Remove the driveshaft.
4.
Remove the oil seal from the extension housing, using seal remover T71P−7657−A or equivalent.
To install:
Before install the replacement seal, inspect the sealing surface of the universal joint yoke for scores. If scoring
is found, replace the yoke.
5.
Install the new seal, using seal installer T74P−77052−A or equivalent. Coat the inside diameter at the
end of the rubber boot portion of the seal with long−life lubricant (C1AZ−1590−BA or equivalent).
6.
Align the matchmarks and install the driveshaft.
7.
Lower the vehicle.
8.
Reconnect the negative battery cable.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
Extension housing seal removal
781