Extension Housing Seal; Removal & Installation - Ford Ranger Maintaince And Repair Manual

4. Clean the area around the switch, then remove the switch.
To install:
5. Install the switch and tighten 8−11 ft. lbs. (11− 16Nm).
6. Reconnect the harness connector to the switch.
7. Lower the vehicle.
8. Reconnect the negative battery cable.

Extension Housing Seal

REMOVAL & INSTALLATION
Two Wheel Drive Models
1. Disconnect the negative battery cable.
2. Raise and support the vehicle safely.
3. Place a suitable drain pan beneath the extension housing. Clean the area around the extension housing
seal.
4. Matchmark the driveshaft to the rear axle flange. Disconnect the driveshaft and pull it rearward from
the unit.
5. Remove the extension housing seal using tool T71P−77218−A or equivalent, remove the extension
housing seal.
To install:
6. Lubricate the inside diameter of the oil seal and install the seal into the extension housing using tool
T71P−77022−A. Check to ensure that the oil seal drain hole faces downward.
7. Install the driveshaft to the extension housing. Connect the driveshaft to the rear axle flange. Make
sure the marks made during removal are in alignment. Fit the attaching washer, lockwasher and nuts.
Extension Housing Seal
HOW TO USE THIS BOOK
Extension housing seal removal
759