Ford Ranger Maintaince And Repair Manual page 1111

1. Remove the seat track insulator (Ranger passenger seat only).
2. Remove the 4 seat track−to−floorpan screws (2 each side) and lift the seat and track assembly from
the vehicle.
3. To remove the seat tracks from the seat cushion, position the seat upside down on a clean bench.
4. Disconnect the latch tie rod assembly and assist spring from the tracks.
5. Remove 4 track−to−seat cushion screws (2 each side) from the track assemblies. Remove the tracks
from seat cushion.
To install:
6. Position the tracks to the seat cushion. Install the 4 track−to−seat cushion screws (2 each side) and
tighten.
7. Connect the latch tie rod assembly and assist spring to the tracks.
8. Position the seat and track assembly in the vehicle.
9. Install 4 track−to−floorpan screws and tighten to specification.
10. Install the seat track insulators (Ranger passenger seat only).
1134
HOW TO USE THIS BOOK
Click to enlarge
60/40 split seat−Explorer
Click to enlarge
REMOVAL & INSTALLATION