Ford Ranger Maintaince And Repair Manual page 904

... then remove the inner wheel bearing. Thoroughly clean and inspect all of the parts for wear or
To install:
13. If the inner and outer cups were removed, use bearing driver handle tool T80−900−W or equivalent
and replace the cups. Be sure to seat the cups properly in the hub.
14. Use a bearing packer tool and properly repack the wheel bearings with the proper grade and type
grease. If a bearing packer is not available work as much of the grease as possible between the rollers
and cages. Also, grease the cone surfaces.
15. Position the inner bearing cone and roller assembly in the inner cup. A light film of grease should be
included between the lips of the new grease seal.
16. Install the grease seal by driving in place with hub seal replacer tool T83T−1175−B and Driver
Handle T80T−900−W.
17. Install the hub and rotor assembly onto the spindle. Keep the hub centered on the spindle to prevent
damage to the spindle and the retainer.
18. Install the outer bearing cone and roller assembly
19. Carefully install the rotor onto the spindle. Install the outer wheel bearing in the rotor.
20. Install the inner adjusting nut with the pin facing out. Tighten the inner adjusting nut to 35 ft. lbs. (6
Nm) to seat the bearings.
21. Follow the appropriate wheel bearing adjustment procedures.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
Pry out the grease seal on the back of the rotor/hub assembly ...
damage
919