Regulator
EXCEPT EXPLORER/MOUNTAINEER FRONT DOOR
1.
Remove the door trim panel. If equipped with power windows, disconnect the wire from the regulator
2.
Support the glass in the full UP position or remove completely.
3.
Remove the window guide and glass bracket if equipped.
4.
Remove the center pins from the regulator attaching rivets.
5.
Drill out the regulator attaching rivets using a
6.
Disengage the regulator arm from the glass bracket and remove the regulator.
7.
Installation is the reverse of removal.
rivets to attach the regulator.
EXPLORER/MOUNTAINEER FRONT DOOR
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
Power regulator−Ranger shown
Click to enlarge
1
/
in. (6mm) drill bit.
4
1
1
/
in.−20 x
/
in. bolts and nuts may be used in place of the
4
2
1127