Ford Ranger Maintaince And Repair Manual page 1003

Hide thumbs Also See for Ranger:

Table of Contents

Repeat the procedure and remove the secondary return spring, adjuster cable and its guide

Remove the cable guide from the secondary shoe.

Remove the shoe hold−down springs, shoes, adjusting screw, pivot nut, and socket. Note the color of

each hold−down spring for assembly. To remove the hold−down springs, reach behind the brake

backing plate and place one finger on the end of one of the brake hold−down spring mounting pins.

Using a pair of pliers, grasp the washer−type retainer on top of the hold−down spring that corresponds

to the pin that you are holding. Push down on the pliers and turn them 90° to align the slot in the

washer with the head on the spring mounting pin. Remove the spring and washer retainer and repeat

this operation on the hold−down spring on the other shoe.

Remove the parking brake link and spring. Disconnect the parking brake cable from the parking brake

After removing the rear brake secondary shoe, disassemble the parking brake lever from the shoe by

removing the retaining clip and spring washer.

REMOVAL & INSTALLATION

HOW TO USE THIS BOOK

Also remove the anchor pin plate

Troubleshooting

Mountaineer Explorer