Ford Ranger Maintaince And Repair Manual page 646

To install:
11. Before installation, it would be wise to perform the following:
1. Double−check the tightness of the sending unit/fuel pump locking ring. If it is already loose,
now would be a good time to remove it and check the condition of the gasket underneath.
2. Ensure that all metal shields are reinstalled in their original positions and that the fasteners are
secure.
3. Be sure that the fuel vapor valve is completely installed on top of the fuel tank.
4. Make all necessary fuel line or wiring connections which will be inaccessible after the fuel
tank is installed.
12. Raise the fuel tank into position in the vehicle. If necessary, attach the fuel lines and sending unit
electrical connector before the tank is in its final position.
13. Lubricate the fuel filler pipe with a water−based lubricant. Install the tank onto the filler pipe, then
bring the tank into final position. Be careful not to deform the tank.
14. Position the tank straps around the tank and start the retaining nut or bolt. Align the tank with the
straps. If equipped, be sure the fuel tank shields are installed with the straps and are positioned
correctly.
15. Check the hoses and wiring on top of the tank. Make sure they are correctly routed and will not be
pinched between the tank and body.
16. Tighten the fuel tank strap retaining nuts or bolts to 20−5 ft. lbs. (3−41 Nm).
646
HOW TO USE THIS BOOK
Exploded view of the Ranger Regular Cab fuel tank assembly
Click to enlarge
REMOVAL & INSTALLATION