1.
Disconnect the wiring from the harness.
2.
Remove the sensor hold−down bolt and remove the sensor from the axle.
To install:
3.
Thoroughly clean the mounting surfaces. Make sure no dirt falls into the axle. Clean the magnetized
sensor pole piece. Metal particles can cause sensor problems. Replace the O−ring.
4.
Coat the new O−ring with clean engine oil.
5.
Position the new sensor on the axle. It should slide into place easily. Correct installation will allow a
gap of 0.005−0.045 in.
6.
Torque the hold−down bolt to 25−30 ft. lbs.
7.
Connect the wiring.
Front Speed Sensor Ring
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
Rear wheel speed sensor−4−wheel ABS
Click to enlarge
1067