Ford Ranger Maintaince And Repair Manual page 752

5. On 2WD vehicles, matchmark the driveshaft to the rear axle flange. Position a drain pan under the
tailend of the transmission. Remove the driveshaft−to−rear axle flange fasteners and pull the
driveshaft rearward to disconnect it from the transmission.
6. Disconnect the clutch hydraulic line a the clutch housing. Plug the lines.
7. Disconnect the speedometer from the transfer case/extension housing.
8. Disconnect the starter motor, back−up lamp and, if equipped, neutral sensing switch harness
connector.
9. Place a wood block on a service jack and position the jack under the engine oil pan.
10. On 4WD vehicles, remove the transfer case from the vehicle.
11. Remove the starter motor.
12. Position a transmission jack, under the transmission.
13. Remove the transmission−to−engine retaining bolts and washers.
14. Remove the nuts and bolts attaching the transmission mount and damper to the crossmember.
15. Remove the nuts and bolts attaching the crossmember to the frame side rails and remove the
crossmember.
16. Lower the engine jack slightly to angle the transmission assembly. Work the clutch housing off the
locating dowels and slide the clutch housing and the transmission rearward until the input shaft clears
the clutch disc.
17. Lower the transmission jack and remove the transmission from the vehicle.
To install:
18. Check that the mating surfaces of the clutch housing, engine rear and dowel holes are free of burrs,
dirt and paint.
19. Place the transmission on the transmission jack. Position the transmission under the vehicle, then raise
it into position. Align the input shaft splines with the clutch disc splines and work the transmission
forward into the locating dowels.
20. Install the transmission−to−engine retaining bolts and washers. Tighten the retaining bolts to
specifications. Remove the transmission jack.
21. Install the starter motor. Tighten the attaching nuts.
22. Raise the engine and install the rear crossmember, insulator and damper and attaching nuts and bolts.
Tighten and torque the bolts to specification.
23. On 4WD vehicles, install the transfer case.
24. On 2WD vehicles, insert the driveshaft into the transmission extension housing and install the center
bearing attaching nuts, washers and lockwashers. Connect the driveshaft to the rear axle drive flange.
25. Connect the starter motor, back−up lamp and, if equipped, neutral sensing switch connectors.
26. Connect the hydraulic clutch line and bleed the system.
27. Install the speedometer cable.
28. Check and adjust the fluid level.
29. Lower the vehicle.
30. Install the gearshift lever assembly. Install the boot cover and bolts.
31. Reconnect the negative battery cable.
32. Check for proper shifting and operation of the transmission.
Chilton® Automotive Information Systems. © 2004 Thomson Delmar Learning.
762
HOW TO USE THIS BOOK
REMOVAL & INSTALLATION