Shifter & Linkage Adjustments; Shift Handle; Removal & Installation - Ford Ranger Maintaince And Repair Manual

SHIFTER & LINKAGE ADJUSTMENTS
Both of the 5−speed transmissions are directly controlled with a floor shift mechanism built into the
transmission extension housing. There are no adjustments necessary on these transmissions.

Shift Handle

REMOVAL & INSTALLATION
1. Disconnect the negative battery cable.
Do not remove the shift knob, unless the shift knob or boot is to be replaced. Otherwise, remove the
shift knob, boot and lever as an assembly.
2. If necessary, remove the shift lever knob on the Mitsubishi 5−speed transmission as follows:
1. Remove the plastic shift pattern insert from the shift knob.
2. Heat the shift lever knob to 140−180°F (60−82°C), using a heat gun.
3. Position a block of wood beneath the shift lever knob and carefully hammer the knob from
the lever. Be careful not to damage the finish on the shift lever.
3. Place the gearshift lever in Nposition.
4. Remove the shifter boot retainer screws and slide the boot up the lever.
5. Remove the shift lever−to−extension housing/transfer case adapter housing retaining bolts. Pull the
gearshift lever straight up and away from the gearshift lever retainer.
756
HOW TO USE THIS BOOK
SHIFTER & LINKAGE ADJUSTMENTS