Set Maclock Trap - Enterasys Matrix 2G4072-52 Configuration Manual

14.3.9.11 set maclock trap

Use this command to enable or disable MAC lock trap messaging. When enabled, this authorizes
the device to send an SNMP trap message if an end station is connected that exceeds the maximum
values configured using the set maclock firstarrival and set maclock static commands. Violating
MAC addresses are dropped from the device's routing table.
set maclock trap port_string {enable | disable}
Syntax Description
port_string
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable MAC lock trap messaging on fe.2.3:
Matrix(rw)->set maclock trap fe.2.3 enable
Specifies the port on which MAC lock trap messaging
will be enabled or disabled. For a detailed description of
possible port_string values, refer to
Enables or disables MAC lock trap messaging.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
Configuring MAC Locking
Section 4.1.1.
14-131