Set Maclock - Enterasys Matrix 2G4072-52 Configuration Manual

14.3.9.5

set maclock

Use this command to create a static MAC address and enable or disable MAC locking for the
specific MAC address and port. When created and enabled, this allows only the end station
designated by the MAC address to participate in frame relay.
set maclock mac_address port_string {create | enable | disable}
NOTE: Configuring one or more ports for MAC locking requires globally enabling it on
the device first using the set maclock enable command as described in
Section 14.3.9.3.
Syntax Description
mac_address
port_string
create
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create a MAC locking association between MAC address
00-a0-c9-0d-32-11 and port fe.2.3:
Matrix(rw)->set maclock 00-a0-c9-0d-32-11 fe.2.3 create
Specifies the MAC address for which MAC locking will
be created, enabled or disabled.
Specifies the port on which to create, enable or disable
MAC locking. For a detailed description of possible
port_string values, refer to
Establishes a MAC locking association between the
specified MAC address and port. Create automatically
enables MAC locking between the specified MAC
address and port.
Enables or disables MAC locking between the specified
MAC address and port.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
Configuring MAC Locking
Section 4.1.1.
14-125