Example usage:
To configure the repeating mode:
System Log Commands
The System Log commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
enable syslog
disable syslog
create syslog_server
delete syslog_server
show syslog_server
show syslog
Each command is listed in detail below.
enable syslog
Purpose
Syntax
Description
106
Figure 110. config sntp_dst command from/to
Used to enable the System Log on the switch.
enable syslog
This command allows you to enable System Log
on the switch.
Parameters
Ipaddress <ipaddress> port <port>
facility <local0-7>
Idx <idx>