Igmp Snooping Configuration Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
acl-name
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following is a CLI display output example.
(Routing)#show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08

IGMP Snooping Configuration Commands

This section IGMP snooping configuration. The supported IGMP Versions are 1, 2, and 3. The feature
conserves bandwidth allowing IP multicast traffic forwarding to connected hosts that request multicast
traffic.
5-466 set igmp
Enable IGMP Snooping on the system (Global Config Mode), a single or a range of interfaces.
Configuration is also available to enable IGMP snooping on a single or all part participating VLANs.
The IGMP application supports the following:
•
Validation of the IP header checksum (as well as the IGMP header checksum) and discarding of
the frame upon checksum error.
•
Maintain forwarding table, MAC address to the IP address.
•
Flooding of unregistered multicast data packets to all ports in the VLAN.
No command disables IGMP Snooping, a single or a range of interfaces, or a VLAN.
set igmp [vlan_id]
no set igmp [vlan_id]
(Optional) Display ARP Access list configuration.
489