Honda Accord 2008 Manual page 553

07/11/02 09:11:59 61TA0000_110_0234
PGM-FI System
ECM/PCM Replacement (cont'd)
14. Remove the cover (A) and the bracket (B) from the
ECM/PCM (C).
＊０３
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
15. Install the ECM/PCM in the reverse order of
removal.
16. Do the battery installation procedure (see page
22-90).
NOTE: While doing the battery installation
procedure, do not start the engine.
17. Turn the ignition switch to ON (II).
18. Manually input the VIN to the ECM/PCM with the
HDS.
NOTE: DTC P0630 ''VIN Not Programmed or
Mismatch'' may be stored because the VIN has not
been programmed into the ECM/PCM; ignore it,
and continue this procedure.
19. If the READ DATA (engine oil life) failed in step 8,
go to step 22 (A/T model) or step 25 (M/T model).
Otherwise, go to step 20.
20. Select the PGM-FI system with the HDS.
21. Select the REPLACE ECM/PCM MENU, then WRITE
DATA, and follow the screen prompts.
NOTE: If the WRITE DATA indicates FAILED,
continue with this procedure.
11-234
22. A/T models: If the READ DATA (ATF life) failed in
23. A/T models: Select the A/T SYSTEM with the HDS.
A
24. A/T models: Select the REPLACE TCM/PCM MENU,
B
25. Select IMMOBI system with the HDS.
26. Enter the immobilizer code with the ECM/PCM
27. If the TP POSITION CHECK failed in step 7 clean the
C
28. If the READ DATA failed in step 8 or the WRITE
29. If the READ DATA failed in step 10 or the WRITE
30. Select PGM-FI system, and reset the ECM/PCM with
31. Update the ECM/PCM if it does not have the latest
32. Do the ECM/PCM idle learn procedure (see page
33. Do the CKP pattern learn procedure (see page 11-5).
step 10, go to step 25. Otherwise go to step 23.
then WRITE DATA, and follow the screen prompts.
NOTE: If the WRITE DATA indicates FAILED,
continue with this procedure.
replacement procedure in the HDS; it allows you to
start the engine.
throttle body (see page 11-385), then go to step 28.
DATA failed in step 21, replace the engine oil
(see page 8-10) and engine oil filter (see page 8-11),
then go to step 29 (A/T model) or step 30 (M/T
model).
DATA failed in step 24, replace the ATF (see page
14-242), then go to step 30.
the HDS.
software (see page 11-231).
11-343).