Dhcp Local Relay Commands - D-Link DES-3028 Cli Reference Manual

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
The DHCP Local Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config dhcp_local _relay
enable dhcp_local _relay
disable dhcp _local_relay
show dhcp _local_relay
Each command is listed, in detail, in the following sections.
config dhcp_local_relay vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DHCP local relay for the default vlan:
DES-3028P:4#config dhcp_local_relay vlan default state enable
Command: config dhcp_local_relay vlan default state enable
Success.
DES-3028P:4#
enable dhcp_local_relay
Purpose
Syntax
Description
Parameters
Restrictions
DHCP L
Parameters
vlan[<vlan_name 32> | vlanid <vidlist>] state [enable |
disable]
Used to enable/disable DHCP local relay function to vlan.
config dhcp_local_relay vlan [<vlan_name 32>| vlanid <vidlist>]
state [enable | disable]
The config dhcp_local_relay vlan command is used to enable /disable
DHCP local relay function for specified vlan. When DHCP local relay is
enabled for the VLAN, the DHCP packet will be relayed in broadcast way
without change of the source MAC address and gateway address. DHCP
option 82 will be automatically added.
<vlan_name 32>  The name of the VLAN to be enabled DHCP local
relay.
<vidlist>  Specifies a range of VLAN IDs to be configured.
state  Enable or disable DHCP local relay for specified vlan.
Only Administrator-level users can issue this command.
Used to enable the DHCP local relay function on the switch.
enable dhcp_local_relay
The enable dhcp_local _relay command globally enables the DHCP local
relay function on the switch.
None.
Only Administrator-level users can issue this command.
OCAL
260
35
R C
ELAY OMMANDS