Password Recovery Commands - D-Link xStack DGS-3400 Series Reference Manual

xStack
The Password Recovery commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
reset config
reboot
reset account
reset password
show account
Each command is listed, in detail, in the following sections.
reset config
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To reset the configuration:
DGS-3450:admin# reset config
Command: reset config
Are you sure to proceed with reset config ?(y/n) y
Success.
DGS-3450:admin#
reboot
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To exit Reset Configuration Mode and restart the switch:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Parameters
{force_agree(1)}
{force_agree(1)}
{<username>}
Used to reset the configuration.
reset config {force_agree(1)}
Used to reset the configuration.
force_agree – Specify to forcibly agree with the command.
This command is only available in password recovery mode.
Used to exit Reset Configuration Mode and restart the switch.
reboot {force_agree(1)}
The reboot command exit Reset Configuration Mode and restart the switch. And it pops out a
confirmation message to save the current setting.
force_agree – Specify to forcibly agree with the command.
This command is only available in password recovery mode.
P R
ASSWORD
448
59
C
ECOVERY OMMANDS