Removing Clutch Cam And Cam Rod - TOHATSU MFS 4D Service Manual

Using bladed screw driver, shorten spring 1 by referring to
2.
illustration, insert spring pin tool A 4 into hole of clutch 2
to secure spring. Slowly press fit new spring pin 3 from the
other side, putting it on the spring pin tool A and by using
spring pin tool B 5.
Do not reuse removed spring pin.
· Drive spring pin into clutch hole to depth of
approximately 0.5mm from the surface.
· After setting spring pin, check operations of
clutch.
Spring Pin Tool A (ϕ3.5) 4:
P/N. 369-72217-0
Spring Pin Tool B (ϕ3.5) 5:
P/N. 369-72218-0

14) Removing Clutch Cam and Cam Rod

Ass'y
Remove bolt 1, stopper 2, and then pull cam rod ass'y
1.
3 upward to remove.
15) Disassembly of Clutch Cam and
Cam Rod Ass'y
Remove spring pins 2 and clutch cam 3 from cam rod 1.
1.
· Use spring pin tool A to remove spring pins.
· Do not reuse removed spring pins.
Spring Pin Tool A (ϕ3.0):
P/N. 345-72227-0
16) Inspection of Clutch Cam and Cam Rod
Check cam rod 1 and clutch cam 3 for crack and wear.
1.
Replace if necessary.
4st 4/5/6 2020
CAUTION
6
4
5
1
2
3
1
GEAR GEAR
GEAR
2
3
2 Spring Pin
Do not reuse.
7
3
4
6
Forward
direction
6-17
6