Servicing The Internal Usb Flash Drives (Cru) - Oracle X6-2 Service Manual

3. Hold the riser in one hand and use your other hand to carefully insert the PCIe
card connector into the riser.
4. Install the PCIe riser.
For instructions, see

Servicing the Internal USB Flash Drives (CRU)

Caution -
discharge. This sensitivity can cause the component to fail. To avoid damage, ensure that you
follow antistatic practices as described in
Caution -
flash drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
This section covers the following procedures:
"Remove an Internal USB Flash Drive" on page 114
■
"Install an Internal USB Flash Drive" on page 115
■
Related Information
"Extend the Server to the Maintenance Position" on page 56
■
"Install the PCIe Riser Into PCIe Slots 3 and 4" on page
These procedures require that you handle components that are sensitive to static
Ensure that all power is removed from the server before removing or installing a
Servicing the Internal USB Flash Drives (CRU)
"Take Antistatic Measures" on page
Servicing CRUs That Require Server Power-Off
105.
59.
113