Table of Contents
Advertisement
5 - 68 WiNG 4.4 Switch System Reference Guide
Once SOLE has been enabled MUs found by the locationing engine will be displayed in the
bottom of the page. For each located MU the following information is displayed:
MAC
Location:
X Coordinate
Location:
Y Coordinate
Timestamp
Zone
NOTE: Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Motorola Solutions RF Switch CLI Reference.
5.8.5 Configuring Aeroscout Parameters
To configure the switch to work with an external Aeroscout RTLS engine:
1.
.Services
>
RTLS
2. Select the
Aeroscout
3. Check the
Enable
This takes effect immediately when the box is checked.
4. Enter the
Multicast MAC Address
specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
NOTE: To use the onboard SOLE engine to locate Aeroscout tags, site parameters, AP
location (Command Line Interface only) and Zone configuration (optional, Command Line
Interface only) must be configured.
Lists the MAC Addresses of all MUs which have been located by the switch.
Displays the value of the X Coordinate for each located MU. The X coordinate is relative to the
origin point of 0,0 in the upper left corner of the site map.
Displays the value of the Y Coordinate for each located MU. The Y coordinate is relative to the
origin point of 0,0 in the upper left corner of the site map.
Displays the last time for each MU that its location was computed by the switch.
Lists the last known zone for each located MU. Zone configuration can be defined using the CLI
interface only. When no zones are configured, the switch defaults the entire site to Zone 0.
from the main menu tree.
tab.
checkbox to globally enable Aeroscout RTLS support on the switch.
used for all Aeroscout tags to send updates via multicast to the MAC address
Located MUs
table at the
Advertisement
Table of Contents
Troubleshooting
