Table of Contents
Advertisement
needs to maintain connectivity with the switch. If switch connectivity is lost, the dependent mode AP-5131 continues
operating as a stand-alone Access Point for a period of 3 days before resetting and executing the switch discovery
algorithm again.
A dependent mode AP cannot be converted into a standalone AP-5131 through a firmware change. Refer to the AP-5131 Hardware/
Software Compatibility Matrix within the release notes bundled with the Access Point firmware
AP-5131-13040-D-WR
AP-5131-40020-D-WR
B.1.4 Licensing
An AAP uses the same licensing scheme as a thin Access Port. This implies an existing license purchased with a switch
can be used for an AAP deployment. Regardless of how many AP300
and/or AAPs are deployed, you must ensure the license used by the switch supports the number of radio ports (both
AP300s and AAPs) you intend to adopt.
B.1.5 Switch Discovery
For an AP-5131 to function as an AAP (regardless of mode), it needs to connect to a switch to receive its configuration.
There are two methods of switch discovery:
•
Auto Discovery using DHCP
•
Manual Adoption Configuration
NOTE
B.1.5.1 Auto Discovery using DHCP
Extended Global Options 189, 190, 191, 192 can be used or Embedded Option 43 - Vendor Specific options can be
embedded in Option 43 using the vendor class identifier:
For AAP 2.0 the Vendor ID is: MotorolaAP.51xx-V2-0-0
For AAP 2.3.1 the Vendor ID is: MotorolaAP.51xx-V2-3-1
(separate by comma, semi-colon, or space delimited)
AP-51XX Encryption IPSec Passphrase (Hashed)**
AP-51XX switch discovery mode
2 = auto discover enabled (using IPSec)
Dependent AP-5131 Dual Radio (Switch Required)
Dependent AP-5131 Single Radio (Switch Required)
To support switch discovery, a switch must be running firmware version 3.1 or
higher. The Access Point must running firmware version 2.0 or higher.
List of Switch IP addresses
Switch FQDN
1 = auto discovery enable
.
Code
189
190
191
192
.
Data Type
String
String
String
String
B - 7
Advertisement
Table of Contents
Troubleshooting
