Table of Contents
Advertisement
4. Refer to the
Information
MAC Address
Displays the Hardware or Media Access Control (MAC) address for the MU. This address is
hard-coded at the factory and cannot be modified.
BSS Address
Displays the MU's BSSID.
IP Address
Displays the current IP address for the MU.
Voice
Displays whether the MU is a voice capable device. Traffic from voice-enabled MUs is
handled differently (higher priority) than traffic from MUs without this capability.
WLAN
Displays the name of the WLAN the MU is currently associated with.
WMM
Displays WMM usage status for the MU, including the access category currently in use. Use
this information to assess whether the MU is using the correct WMM settings in relation to
its intended data traffic type.
5. Refer to the
Traffic
field for the following information:
Pkts per second
Displays the average packets per second received by the MU. The Rx column displays the
average packets per second received on the selected MU. The Tx column displays the
average packets per second sent on the selected MU.
Throughput
Displays the average throughput in Mbps between the MU and the Access Port. The Rx
column displays the average throughput in Mbps for packets received on the selected MU
from the Access Port. The Tx column displays the average throughput for packets sent on the
selected MU from the Access Port.
Avg. Bit Speed
Displays the average bit speed in Mbps on the selected MU. This includes all packets sent
and received.
% Non-unicast
Displays the percentage of the total packets for the MU that are non-unicast packets. Non-
pkts
unicast packets include broadcast and multicast packets.
6. Refer to the
RF Status
field for the following information:
Avg MU Signal
Displays the RF signal strength in dBm for the selected MU.
Avg MU Noise
Displays the RF noise for the selected MU.
Avg MU SNR
Displays the Signal to Noise Ratio (SNR) for the selected MU. The Signal to Noise Ratio is an
indication of overall RF performance on the wireless network.
7. Refer to the
Errors
field for the following information:
Avg Num of Retries Displays the average number of retries for the selected MU. Use this information to assess
potential performance issues.
% Gave Up Pkts
Displays the percentage of packets the switch gave up on for the selected MU.
% of
Displays the percentage of undecryptable packets (packets that could not be processed) for
Undecryptable Pkts
the selected MU.
8. Refer to the
Status
field for the current state of the requests made from applet. This field displays error messages if
something goes wrong in the transaction between the applet and the switch.
field for the following information:
Network Setup 4 - 85
Advertisement
Table of Contents
Troubleshooting
