Motorola WiNG 4.4 Reference Manual page 149

4. Select the Hotspot button from within the
Ensure Advanced is selected from within the
Once the properties of the advanced hotspot have been defined, the file can be installed on the switch and used to support
the hotspot. The following parameters are required to upload the file:
a. Specify a source hotspot configuration file. The file used at startup automatically displays within the
parameter.
b. Refer to the Using drop-down menu to configure whether the hotspot file transfer is conducted using FTP or TFTP.
c. Enter the IP Address
is valid or risk jeopardizing the success of the file transfer.
d. If using FTP, enter the
e. If using FTP, enter the
f. Specify the appropriate
g. Once the location and settings for the advanced hotspot configuration have been defined, click the
to use the hotspot configuration with the switch.
5. Refer to the field, and enter any IP address (for internal or external Web sites) that may be accessed by the
Allow List
Hotspot user without authentication.
6. Check the Use System Name in Hotspot URL
screen as part of the hotspot address.
Authentication
This WLAN's Web Pages are of the
of the server or system receiving the source hotspot configuration. Ensure that the IP address
User ID credentials required to transfer the configuration file from an FTP server.
Password required to send the configuration file from an FTP server.
Path name to the hotspot configuration on the local system disk or server.
to use the
field.
drop-down menu.
System Name specified on the main Switch configuration
Network Setup 4 - 45
File
Install button