Motorola WiNG 4.4 Reference Manual page 351

Last Msg TX Time Displays the Date and Time that the last message was sent to the external Ekahau RTLS engine.
No. of Tag Reports Displays the number of Tag Reports received from the external Ekahau RTLS engine.
10.To use the onboard SOLE engine to locate Ekahau tags check the
checking the box.
11.If the onboard SOLE engine is enabled to locate Ekahau tags, enter a
the known tags are located by the SOLE engine.
12.Click the Apply button to save the
13.Click the Revert button to cancel any changes made within
configuration.
If the onboard SOLE engine is enabled to locate Ekahau tags the following information will be displayed for each located
MU:
MAC Lists the MAC Addresses of all MUs which have been located by the switch.
Location: Displays the value of the X Coordinate for each located MU. The X coordinate is relative to the
X Coordinate origin point of 0,0 in the upper left corner of the site map.
Location: Displays the value of the Y Coordinate for each located MU. The X coordinate is relative to the
Y Coordinate origin point of 0,0 in the upper left corner of the site map.
Timestamp Displays the last time for each MU that its location was computed by the switch.
Zone Lists the last known zone for each located MU. Zone configuration can be defined using the CLI
interface only. When no zones are configured, the switch defaults the entire site to Zone 0.
NOTE: Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Motorola Solutions RF Switch CLI Reference.
Locate Interval value.
Locate Interval
Switch Services 5 - 71
Enable checkbox. This is enabled immediately after
Locate Interval in seconds to specify how often
value and revert back to the last saved