Configuring The Switch For Remote Management; Setting An Ip Address - Motorola EX-3524 Cli Reference Manual

Configuring the Switch for Remote Management

Setting an IP Address

You must establish IP address information for the switch to obtain management
access through the network. This can be done in either of the following ways:
◆
Manual — You have to input the information, including IP address and subnet
mask. If your management station is not in the same IP subnet as the switch,
you will also need to specify the default gateway router.
◆
Dynamic — The switch can send IPv4 configuration requests to BOOTP or
DHCP address allocation servers on the network, or automatically generate a
unique IPv6 host address based on the local subnet address prefix received in
router advertisement messages. An IPv6 link local address for use in a local
network can also be dynamically generated as described in
Address" on page 43.
The current software supports DHCP for IPv6, so an IPv6 global unicast address
for use in a network containing more than one subnet can obtained through
the DHCPv6 server, or manually configured as described in
Address" on page 40.
Manual Configuration
You can manually assign an IP address to the switch. You may also need to specify a
default gateway that resides between this device and management stations that
exist on another network segment. Valid IPv4 addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the CLI program.
Note: The IPv4 address for VLAN 1 is obtained via DHCP by default.
Assigning an IPv4 Address
Before you can assign an IP address to the switch, you must obtain the following
information from your network administrator:
◆
IP address for the switch
◆
Network mask for this network
◆
Default gateway for the network
To assign an IPv4 address to the switch, complete the following steps
1.
From the Global Configuration mode prompt, type "interface vlan 1" to access
the interface-configuration mode. Press <Enter>.
2.
Type "ip address ip-address netmask, " where "ip-address" is the switch IP
address and "netmask" is the network mask for the network. Press <Enter>.
Chapter 1
Configuring the Switch for Remote Management
– 39 –
| Initial Switch Configuration
"Obtaining an IPv6
"Assigning an IPv6