Configuring Snmp Traps; Enabling Trap Configuration - Motorola WiNG 4.4 Reference Manual

7.4 Configuring SNMP Traps

Use the SNMP Trap Configuration screen to enable or disable individual traps or by functional trap groups. It is also used
for modifying the existing threshold conditions values for individual trap descriptions. Refer to the tabs within the SNMP
Trap Configuration screen to conduct the following configuration activities:
•

Enabling Trap Configuration

• Configuring Trap Thresholds
7.4.1 Enabling Trap Configuration
If unsure whether to enable a specific trap, select it and view a brief description that may help your decision. Use
all items to explode each trap category and view all the traps that can be enabled. Traps can either be enabled by group
or as individual traps within each parent category.
To configure SNMP trap definitions:
1. Select Management Access
2. Select the Allow Traps to be generated
the screen. Leaving the checkbox unselected means traps must be enabled by category or individually.
3. Refer to trap categories within the Configuration screen to determine whether traps should be enabled by group or
individually enabled within parent groups.
> SNMP Trap Configuration
checkbox to enable the selection (and employment) of all the traps within
Switch Management 7 - 11
from the main menu tree.
Expand