Motorola WiNG 4.4 Reference Manual page 198

4 - 94 WiNG 4.4 Switch System Reference Guide
3. Click the Global Settings
4. Set an Adoption Preference ID
To define a radio as preferred, the Access Port preference ID should be the same as the adoption preference ID. The
adoption preference ID is used for AP load-balancing. A switch will preferentially adopt Access Ports having the same
adoption-preference-id as the switch itself.
The Adoption Preference ID defines the switch preference ID. The value can be between 1 and 65535. To define radios
as preferred, the Access Port preference ID should be the same as the adoption preference ID. If the value is set to 0,
the switch automatically changes the value to 1.
In a layer 3 environment, the Access Port adoption process is somewhat unique. For more information, see
Configuring Layer 3 Access Port Adoption on page
5. To enable the automatic adoption of non-configured radios on the network, select the
automatically
option to allow adoption even when the Access Port is not configured. Default radio settings are applied to Access
Ports adopted automatically.
6. To limit the number of voice-enabled MUs which are associated, click the
Limiting voice MU traffic in a supported WLAN is a good idea to maintain data rates, voice quality, and throughput.
WMM admission control is a mechanism for limiting traffic on a given access category. Per the recommendation of the
802.11e specification, Motorola Solutions limits support of this feature to voice and video. The switch configures the
AP to broadcast that admission control is configured by default on AP300s(not clear).
7. To use WIPS, enter a
corresponding fields.
NOTE: When using an AP-5131for use with WIPS and as a sensor, you must first
configure the WIPS server IP Addresses before converting the AP-5131 to a sensor.
8. Click the Configure Port Authentication
information.
9. Click OK to save the changes and return to the previous screen.
Port Authentication
To configure the port authentication settings on an Access Port:
1. Select Network
button to display a screen containing global settings, which apply to all radios on the switch.
value between 1 and 65535.
option. Default radio settings are applied to Access Ports when automatically adopted. Enable this
Primary WIPS Server Address
button to open a new dialogue with port authentication configuration
> Access Port Radios from the main menu tree.
4-134.
Voice Call Admission Control
and Secondary WIPS Server Address
Adopt unconfigured radios
checkbox.
into the