Motorola WiNG 4.4 Reference Manual page 294

5 - 14 WiNG 4.4 Switch System Reference Guide
2. Click the Relay
3. Refer to the Interfaces field for the names of the interfaces available to route information between the DHCP Server
and DHCP clients. If this information is insufficient, consider creating a new IP pool or edit an existing pool.
4. Click the Edit
that can be modified for the DHCP relay.
5. To delete an existing DHCP pool from the list of those available to the switch, highlight the pool from within the
Network Pool field and click the
NOTE: The interface VLAN and gateway interface should have their IP addresses set. The
interface VLAN and gateway interface should not have DHCP client or DHCP Server
enabled. DHCP packets cannot be relayed to an onboard DHCP Server. The interface VLAN
and gateway interface cannot be the same.
6. Click the Add
a. Use the Interface
switch, the number of interfaces available grows.
b. Add Servers
c. Click OK to save and add the changes to the running configuration and close the dialog.
d. Click Cancel
tab.
button to modify the properties displayed on an existing DHCP pool. Refer to step 7 for the information
Delete button.
button to create a new DHCP pool.
drop-down menu to assign the interface used for the DHCP relay. As VLANs are added to the
as needed to supply DHCP relay resources.
to close the dialog without committing updates to the running configuration.