Motorola WiNG 4.4 Reference Manual page 364

6 - 12 WiNG 4.4 Switch System Reference Guide
4. Refer to the Violation Parameters
Violation Type
Trigger Against
(Auth, Unauth,
Ignore)
Threshold Values
for Mobile Unit
Threshold Values
for Radio
Time to Filter
CAUTION: Setting MU threshold values too low can jeopardize MU performance or break
the MU's connection.
NOTE: Setting a violation parameter to 0 will disable that option.
5. When using the
ESSIDs for the violation parameter. To enter this information, select
the Bad Essid Config
NOTE: If using the
are entered in the
6. Click on Apply
7. Click on Revert
field to define threshold values that trigger an alarm:
Displays the name of the violation for which threshold values are set in the MU, radio and switch
columns.
Displays what conditions will trigger the violation parameter against Authorized APs,
Unauthorized APs and Ignored APs. If a violation is triggered by an AP type it will display with a
green check box. If it is not triggered on an AP type it will display with a red X.
Set the MU threshold value for each violation type. If exceeded, the MU will be filtered and
displayed within the Filtered MUs screen.
Set the radio threshold value for each violation type. If exceeded, the radio will be filtered and
displayed within the Filtered Radios screen.
Set the Time to Filter interval (in seconds) the switch uses to filter out MUs defined as committing
a violation. Refer to Viewing Filtered MUs on page 6-13 to review the contents of the MUs that
have been filtered thus far.
Frames with known bad
button to launch a dialogue box where bad ESSIDs can be added and removed.
Frames with known bad ESSIDs
Bad Essid Config
button to save the configuration.
to rollback to the previous configuration.
ESSIDs violation parameter it is necessary to enter a list of known bad
Frames with known bad ESSIDs
violation parameter if no ESSIDs
dialogue, this parameter will not function.
and then click