Table of Contents
Advertisement
5 - 66 WiNG 4.4 Switch System Reference Guide
5. The AP Information section displays the following information about APs:
AP MAC
Location:
X Coordinate
Location:
Y Coordinate
Location:
Z Coordinate
Status
Switch IP
11a Radio
11b Radio
6. Click the
Apply
configuration.
7. Click the
Revert
configuration.
5.8.3.1 Adding AP Location Information
1. To add AP Location information for your site: Select
2. Select the
Site
3. Click the
Add
5.8.4 Configuring SOLE Parameters
To configure the switch's internal SOLE locationing engine:
Lists the MAC Addresses of all APs which have been configured for RTLS.
Displays the value of the X Coordinate for each AP. The X coordinate is relative to the origin point
of 0,0 in the upper left corner of the site map. This value is user configured and not detected by
the switch. For information on how to configure AP location information, see Chapter 5, Adding
AP Location Information.
Displays the value of the Y Coordinate for each AP. The Y coordinate is relative to the origin point
of 0,0 in the upper left corner of the site map. This value is user configured and not detected by
the switch. For information on how to configure AP location information, see Chapter 5, Adding
AP Location Information.
Displays the value of the Z Coordinate for each AP. The Z coordinate is the height of the AP relative
to the lowest point of the site. This value is user configured and not detected by the switch. For
information on how to configure AP location information, see Chapter 5, Adding AP Location
Information.
Displays the status value for each AP.
Displays the IP address of switch associated with each AP configured for RTLS.
Displays the Index, MAC Address, Power and Channel information for the 802.11a radio on each
AP.
Displays the Index, MAC Address, Power and Channel information for the 802.11b radio on each
AP.
button to save the changes made within this screen. Clicking Apply overwrites the previous
button to disregard any changes made within this screen and revert back to the last saved
tab.
button.
Services
>
RTLS
from the main menu tree.
Advertisement
Table of Contents
Troubleshooting
