Table of Contents
Advertisement
7 - 28 WiNG 4.4 Switch System Reference Guide
4. Configure the following Radius Server attributes:
Radius Server IP
Address
Radius Server Port
Number of retries to
communicate with
Radius Server
Time to wait for
Radius Server to reply
Encryption key shared
with Radius Server
5. Refer to the
Status
something goes wrong in the transaction between the applet and the switch.
6. Click on
OK
to complete the addition of the Radius Server.
7. Click
Cancel
7.6.2.3 External Radius Server Settings
When using an external Radius Server with the switch, ensure that the following values are configured on your server to
ensure maximum compatibility with the switch.
Provide the IP address of the external Radius server. Ensure this address is a valid IP address and not a
DNS name.
Enter the TCP/IP port number for the Radius Server. The port range available for assignment is from 1 -
65535.
Enter the maximum number of times for the switch to retransmit a Radius Server frame before it times
out the authentication session. The available range is between 0 - 100.
Enter the maximum number of times the switch can retransmit a Radius Server frame before it times out
of the authentication session. The available range is between 0 - 100.
Enter the encryption key the switch and Radius Server share and must validate before the user based
authentication provided by the Radius Server can be initiated.
field for the current state of the requests made from applet. This field displays error messages if
to revert back to the last saved configuration without saving any of your changes.
Advertisement
Table of Contents
Troubleshooting
