Viewing The Detailed Contents Of A Config File - Motorola WiNG 4.4 Reference Manual

2. To view the contents of a config file in detail, select a config file by selecting a row from the table and click the
button. For more information, see
3. Select a configuration (other than the start-up-config or running config) and click the
on the switch and replace the existing startup-config file.
If a file (for example, sample-config) is selected, a message displays stating, "When sample-config is installed, it will
replace start-up config. Are you sure you want to install sample-config." Click
NOTE: Selecting either the startup-config or running-config does not enable the Edit
button. A different configuration must be available to enable the Edit function for the
purposes of replacing the existing startup-config.
4. To permanently remove a file from the list of configurations available to the switch, select a configuration file from the
table and click the
If startup-config is deleted, a prompt displays stating the default switch startup-config will automatically take its place.
The switch running-config cannot be deleted.
5. To restore the system's default configuration and revert back to factory default, click the
NOTE: After setting the switch to revert to factory default settings, the system must be
rebooted before the default settings take effect. When this occurs, the switch IP address
may change.
6. Click the Transfer Files
information, see

3.3.1 Viewing the Detailed Contents of a Config File

The View screen displays the entire contents of a configuration file. Motorola Solutions recommends a file be reviewed
carefully before it is selected from the Config Files screen for edit or designation as the switch startup configuration.
1. Select a configuration file from the Configuration screen by highlighting the file.
2. Click the View button to see the contents of the selected configuration file.
Viewing the Detailed Contents of a Config File on page
Delete button.
button to move a target configuration file to a secure location for later use. For more
Transferring a Config File on page
Yes
3-28.
Switch Information 3 - 27
View
3-27.
Install button to install the file
to continue.
Restore Defaults button.