Motorola WiNG 4.4 Reference Manual page 471

2. Select the Beacon Table
3. Select the Enable Enhanced Beacon Table
information.
4. Use Scan Interval value to enter the interval used by the radio between scans. The radio scans each channel for the
defined interval. The default value is 10 seconds.
5. Use the Scan Time value to enter the duration of the scan. The radio scans each channel for the defined interval. The
default value is 100 milliseconds.
6. Define a Max Number of APs
available range is from 0 to 512.
7. Refer to 802.11a Channel Set
provided to the switch, which then makes an 802.11a radio scan for the configured channels.
Allowed Displays the channels available to the AP. The channel list is country specific and differs from
country to country.
Add -> Select a channel frequency and click the
list box. You can select multiple channels and add them to the
button and use the mouse to select multiple channels. The switch uses an 802.11a radio to scan
the selected channels to detect any rogue AP's.
<- Remove Select the channel's frequency from the Configured list box and click
channel from the list of channels provided to the switch.
Configured Displays the channels provided to the switch. The switch makes all the 802.11a radios move to
the selected channel and scan (one at a time), for a configurable interval.
Enable all Select the
receive beacons.
Disable all Select the
receiving beacons.
tab.
checkbox to allow the AP to receive beacons and association
value to set the number of detected APs displayed in the Beacon Found table. The
field to select channels for the 802.11a transmission band. The channel information is
Enable all button (within the 802.11a Radios field) to enable all 802.11a radios from
Disable all button (within the 802.11a Radios field) to disable all 802.11a radios from
Add -> button to include the channel to the
Configured
Switch Security 6 - 119
Configured
list box. Press the Ctrl
<- Remove to remove a