Configuring Radio Groups For Mu Load Balancing - Motorola WiNG 4.4 Reference Manual

For information on revising the weight assigned to each radio in respect to its intended operation within its assigned
WLAN, see Editing the WLAN Configuration on page
To view existing radio bandwidth weight settings:
1. Select Network
2. Click the Bandwidth
Bandwidth information displays per radio with the following data:
Index
Description
QoS Weight

4.7.6 Configuring Radio Groups for MU Load Balancing

In order to do MU load balancing, radios must be grouped. Usually, two radios with similar characteristics and
geographically close to each other can be grouped together.
By default, a radio is not in any group and the load balancing algorithm would not apply to it.
To configure a group of radios together:
1. Select Network
2. Go to the Configuration
> Access Port Radios from the main menu tree.
tab.
The Index is the numerical index (device identifier) used with the device radio. Use this index
(along with the radio name) to differentiate the radio from other device radios.
The displayed name is the name used with the device radio. Use this name (along with the
radio index) to differentiate the radio from other device radios.
Displays the Quality of Service weight for the AP. The default value for the weight is 1. AP
QoS will be applied based on the QoS weight value with the higher values given priority.
> Access Port Radios from the main menu tree.
tab.
4-27.
Network Setup 4 - 111