Editing Snmp Trap Receivers; Adding Snmp Trap Receivers - Motorola WiNG 4.4 Reference Manual

7 - 18 WiNG 4.4 Switch System Reference Guide
5. Click the Add
v3 designation to the new trap.
Add trap receivers as needed if the existing trap receiver information is insufficient. For more information, see
SNMP Trap Receivers on page

7.5.1 Editing SNMP Trap Receivers

Use the Edit screen to modify the trap receiver's IP Address, Port Number and v2c or v3 designation. Consider adding a
new receiver before editing an existing one or risk overwriting a valid receiver. Edit existing destination trap receivers as
required to suit the various traps enabled and their function in supporting the switch managed network.
To edit an existing SNMP trap receiver:
1. Select Management Access > SNMP Trap Receivers
2. Select (highlight) an existing SNMP trap receiver and click the
3. Modify the existing IP address if it is no longer a valid address.
If it is still a valid IP address, consider clicking the
new address without overwriting this existing one.
4. Define a Port Number
5. Use the Protocol Options
6. Click OK to save and add the changes to the running configuration and close the dialog.
7. Refer to the Status
something goes wrong in the transaction between the applet and the switch.
8. Click Cancel

7.5.2 Adding SNMP Trap Receivers

The SNMP Add screen is designed to create a new SNMP trap receiver. Use the Add screen to create a new trap receiver
IP Address, Port Number and v2c or v3 designation. Add new destination trap receivers as required to suit the various traps
enabled and their function in supporting the switch managed network.
To add a new SNMP trap receiver:
1. Select Management Access > SNMP Trap Receivers
button to display a sub-screen used to assign a new Trap Receiver IP Address, Port Number and v2c or
7-18.
for the trap receiver.
drop-down menu to specify the trap receiver as either a SNMP v2c or v3 receiver.
field for the current state of the requests made from applet. This field displays error messages if
to close the dialog without committing updates to the running configuration.
from the main menu tree.
Edit button.v
Add button from within the SNMP Trap Receivers screen to add a
from the main menu tree.
Adding