Configuring Wmm - Motorola WiNG 4.4 Reference Manual

4 - 64 WiNG 4.4 Switch System Reference Guide
4. Refer to the Packet Rates
from 1.0 to 54.0 Mbps. If a large number of packets are sent and received at a slower data rate, then perhaps the switch
is not adequately positioned or configured to support the MUs within that WLAN.
NOTE: The Motorola Solutions RF Management Software is recommended to plan the
deployment of the switch. Motorola Solutions RFMS can help optimize the positioning
and configuration of a switch in respect to a WLAN's MU throughput requirements. For
more information, refer to the Motorola Solutions Website.
5. Refer to the Retry Counts
6. Refer to the Status
something goes wrong in the transaction between the applet and the switch.
7. Click Refresh
8. Click Close to close the dialog and return to the Network > Wireless LANs > Statistics screen.

4.5.3 Configuring WMM

Use the WMM tab to review a WLAN's current index (numerical identifier), SSID, description, current enabled/disabled
designation, and Access Category.
To view existing WMM Settings:
1. Select Network
2. Click the WMM
The WMM tab displays the following information:
Idx
SSID
Description
field to review the number of packets both transmitted (Tx) and received (Rx) at data rates
field to review the number of packets requiring retransmission from the switch.
field for the current state of the requests made from applet. This field displays error messages if
to update the Packet Rate and Retry Count data displayed within the screen.
> Wireless LANs from the main menu tree.
tab.
Displays the WLANs numerical identifier. This field is displayed in a two part format. The first
number is the WLAN index and the second number is a sub-index corresponding to the access
category. Click the Edit
Note: The available WLAN index range is from 1-24 for RFS4000.
Displays the Service Set ID (SSID) associated with each WLAN.
Displays a brief description of the WLAN.
button to modify this property.