22
Assembling the Mirror Position-
ing Tool
1) Remove the screw from position B indicated in
Figure 2-233.
Position B
Longest pin
Note:
Shortest pin not used.
Figure 2-233
2) Fit the screw removed in step 1) in position A;
then, tighten it slightly.
3) Spread the arm out of the main frame until it
comes into contact with the stopper as indi-
cated in Figure 2-234.
4) Fix the screw in place.
Position A
Figure 2-234
23
plunger to the arrow until the pin
bottom of slot, and fix the screw.
Medium-Length pin
24
position of the guide plate at the front, rear, and rear
left.
1) Slide out the deck toward the front until it stops.
2) Remove the mounting screw from the guide
Guide plate (rear)
Guide plate (left)
STANDARDS AND ADJUSTMENTS
Positioning the Paper Deflecting
Plate Solenoid (SL8)
Loosen the two screws
2
1
Figure 2-235
Setting the Deck Size
To change the paper deck size, change the
plate at the front, rear, and rear left; then, detach
the guide plates.
Screw
Screw
Figure 2-236
, push the solenoid
reach to the
3
Screw
Guide plate (front)
2–13